TDA8902J digital power discharge schematic diagram: Figure 3 is the TDA8902J digital power discharge schematic diagram. In the figure, Rosc is a timing element that determines the oscillation frequency. Rosc can be obtained as 3 × 10 / fs. The value range in the parameter table is 100kHz and 500kHz, and the recommended value is 300kHz. From this, Rosc can be calculated as 10kO. TDA8902J digital power discharge principle diagram
"Non-burning, nicotine for users, low tar content. As the heating temperature (below 500℃) is lower than the combustion temperature of traditional cigarettes (600-900℃), the harmful components produced by tobacco high-temperature combustion pyrolysis and thermal synthesis are reduced, and the release amount of side-flow smoke and environmental smoke (second-hand smoke) is also greatly reduced."
Heating non - combustion products are electronic devices containing tobacco. When you heat them, they produce a nicotine-containing vapor that you can inhale. Hnb Device Oem,Hnb Device Patent,Hnb Device,Hnb Device For Sale Shenzhen MASON VAP Technology Co., Ltd. , https://www.e-cigarettefactory.com
C3 is the grounding capacitance of the feedback circuit, the feedback resistance gown has been made in the IC
Inside the chip. The two together form a first-order low-pass feedback circuit, which has a negative feedback effect on signals below the switching frequency. The shown capacitance is the relative value when fS = 300kHz. Due to the external use of C6 and C7 as bootstrap capacitors, the switching frequency MOSFET in the PWM function block is connected in a half-bridge form. The protection circuit has overvoltage protection, output overcurrent protection, and thermal shutdown functions. It is safe to use.
This circuit also has auxiliary functions such as mute / standby. The standby function uses an external control signal to turn off the internal oscillator, cut off the power supply current when there is no signal, and reduce the standby current to 3mA. The function control of the three states of the standby sound pressure is achieved by inputting three different voltages to the (17) th pin.
Another key component in the circuit is passive low-pass filtering Ll, Cl2 and L2,
Cll. Their value is based on the impedance of the speaker and the frequency required to pass
fc and the Q value of the circuit are required to be determined. Here L1 = 100 UH, C10 =
0, 39 UF, RL: 8R, can be calculated fc = l / 27c (LC) / 2 = 24khz, Q =
RLC / L = 0,03. If RL-5fl and fc remain unchanged, the Q value will become 0.02. general
The Q value is small, the circuit is relatively stable; the Q value is equal to 0, 04 is the most flat response, cut off 
They are different from traditional cigarettes and work by heating tobacco to a very low temperature. Tobacco is heated to 350 ° C in a heat-incombustible device, while traditional cigarettes burn at up to 900 ° C.
Still, the temperature at which non-combustion products are heated is high enough to vaporize and inhale harmful chemicals.
Although both are electronic devices, heated non-combustible products are also different from e-cigarettes or steam devices. These usually use chemical liquids and do not necessarily contain nicotine. E-cigarettes tend to heat liquids to around 250 degrees Celsius to produce vapor.