1. Used capacitors can no longer be used, but can be removed as a periodic inspection to test electrical performance; 2. If the capacitor is charged, discharge it with a resistor of about 1kΩ before use; 3. If the capacitor is stored under conditions of more than 35 ° C and humidity greater than 70%, the leakage current may rise, and the rated voltage may be applied by a resistor of about 1 kΩ before use; 4. Confirm the rated capacity, voltage and polarity of the capacitor before installation; 5. Do not use capacitors that fall on the ground; 6. Do not use deformed capacitors; 7. The positive and negative lead spacing of the capacitor should match the position of the PC board soldering hole. If the capacitor is forcibly inserted into a circuit board whose hole pitch is not matched, stress will act on the lead wire, which may cause the capacitor to short-circuit or increase the leakage current; 8. Insert the capacitor pins or solder pins into the PC board during installation until the bottom of the capacitor is attached to the surface of the PC board. 9. Do not apply more than the specified mechanical pressure. When a pulling force is applied to the capacitor lead-out line, the pulling force acts on the inside of the capacitor, causing a short circuit inside the capacitor, and an open circuit or leakage current rises. The capacitor is soldered to the board and the capacitor is not shaken strongly.
FUNCTION DESCRIPTION
Countdown
socket has an AC outlet, the maximum can output 230 V16A of power,
there are two control modes, that is, countdown off and countdown on. It
is convenient to control the equipment which needs to switch off or
turn on AC. improve the safety of the use of some equipment and save
more energy.
SET TIMER
1,Countdown
plug in the socket, all indicator lights red flash three times, at this
time the socket has no output, for the normal state, into the countdown
state. Click the button, the first red light up, the socket output
after an hour off, and then short press the button can set the socket
timing of 2 H.4H.6H.8H.10H.OFF.
2,Long
press button 3s, all indicator lights green flash three times, at this
time the socket has output, for the regular open state, into the
countdown on state. Click on the button, the first green light on, the
socket is closed an hour later, and then press the button to set the
socket countdown 2 H.4H.6H.8H.10H.OFF.
3,Press button 3 longer S, all indicator lights red light flash 3 times again into countdown mode.
4,Select
the required countdown time mode, the corresponding mode countdown
lights up, start countdown until the end of the countdown time. The
outlet that controls the output will start or stop the output.
5,After the countdown starts, the time indicator will change automatically from high to low until the countdown is over.
NOTE:
1,Check that the power connection is good.
2,Use only indoors and in dry places.
3,This product does not convert AC voltage.
4,Maximum load not exceeding 16A 3680W.
5,Grounding is required for safety.
Countdown Timer Socket Switch, Countdown Timer Plug,Countdown Timer Plug Socket, Energy Saving Countdown Timer Switch Socket, Countdown Timer Switch NINGBO COWELL ELECTRONICS & TECHNOLOGY CO., LTD , https://www.cowellsockets.com